Inverted Peony Clay Cutter
1.5 inches longest side.
For advanced user.
HOW TO USE: Roll clay thinner than normal to allow the clay to rise into the crevices of the cutter when pressed down. (On my atlas Roller I use the #3 setting). Make sure to lay clay on a flat surface such as a tile and gently roll over it to make sure it’s stuck down securely to the tile. You MUST dip your cutter in cornstarch or water to allow the clay to release from the cutter and not pull up.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
1.5 inches longest side.
For advanced user.
HOW TO USE: Roll clay thinner than normal to allow the clay to rise into the crevices of the cutter when pressed down. (On my atlas Roller I use the #3 setting). Make sure to lay clay on a flat surface such as a tile and gently roll over it to make sure it’s stuck down securely to the tile. You MUST dip your cutter in cornstarch or water to allow the clay to release from the cutter and not pull up.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
1.5 inches longest side.
For advanced user.
HOW TO USE: Roll clay thinner than normal to allow the clay to rise into the crevices of the cutter when pressed down. (On my atlas Roller I use the #3 setting). Make sure to lay clay on a flat surface such as a tile and gently roll over it to make sure it’s stuck down securely to the tile. You MUST dip your cutter in cornstarch or water to allow the clay to release from the cutter and not pull up.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
