Erin - 4pc Statement Cutter Set
Sizes based on approximate measurements on the longest side of the cutter.
*After adding jump rings, hanging length is around 2.5”-3” dangle length depending on the size of jump rings used.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
Sizes based on approximate measurements on the longest side of the cutter.
*After adding jump rings, hanging length is around 2.5”-3” dangle length depending on the size of jump rings used.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
Sizes based on approximate measurements on the longest side of the cutter.
*After adding jump rings, hanging length is around 2.5”-3” dangle length depending on the size of jump rings used.
3D Printed with PLA+
.4mm cutting edge for clean cuts and sturdy cutter.
Food safe.
*TIPS: To keep clay from sticking and get a clean edge, dip in cornstarch or water before cutting clay. I recommend rolling clay onto a slick surface like a tile so that the clay will stick to the tile and not lift off when you cut into it. To clean cutters, use warm soapy water. Do not wash in dishwasher.
